So far so good. It is a large piece of equipment however does not feel correspondingly heavy. A lot of the body is moulded plastic but that does not concern me as it's the table that matters. I only need room to cut oak that is 60cms wide at it's widest point so there is ample room. The bed slides apart easily to accommodate larger pieces and this action is clever and sufficient. The fence has a good grip of the table and should not move when being used. It has 2 marker windows to allow specific measurements and is clear to see. It feels very light on the actual table surface and I suspect it might mark or damage easily if subjected to heavy force or implements but with care should stay good. My one and only gripe is the protector piece that covers the blade in use. Try as hard as I could I could not get the tightening wheel to engage in the threaded section on the other side of the plate and could only solve this by using a similar, but longer Bolt from another piece of equipment I have. It cuts well and straight, is not too noisy and the blade stops after use much quicker than my old saw table. I like it. Oh, nearly forgot, it folds in half almost and has wheels so moving and storing is a piece of cake. Another thing, forget the instructions, they were made up by a drunk person in a dark room who thought he was assembling a clown car for the local circus. It's pretty self explanitary and then use the pictures on the box to correct your mistakes. That's what I did. Apart from that, I still like it.