Didn't want to write a review until I've used it for a while. Found some issues with the quality and design problems. Design problem 1, The table inserts or float plates he's very easily damaged, Can I easily be replaced as it's clip system meaning to change it for to fabricate a zero insert it's not possible plus you need to remove the rear fence. Would have been if it was screwed down. And I spare fruit plate for when you're cutting metal. Designful too The laser lens got damaged the first time I started to cut a metal, the metal fragments damage the lens cap. Quarter to control The left side of the slider of the fence the thumb screw is misaligned making it very difficult to slide. The other issue with the fence is the height of the fence for standard model or nun+vision seems a bit too short. Otherwise a good miter saw apart from those issues. Send some photos . If there's any questions please don't hesitate to contact me . At some point I will have to order some replacement parts.