Owner’s Manual for 3PT Trimmer is lacking information. • No information on how to check gear box as far as fluid level or type of grease or fluid that is used. • It say for Cord Head Adjustment “Align the hole in the anti wrap canister with the internal housing at the location shown.” No hole in anti-wrap canister • “Align the hole in the anti wrap canister with the internal housing at the location shown. 2. Insert a Philips head screwdriver into the hole in the anti wrap canister and the hole in the internal housing. 3. Rotate the plastic spherical cap until the screw driver sliders into a hole in the shaft, locking it into place. 4. Looking down at the top of the Frame, turn the plastic spherical cap clockwise until it unscrews completely from the bearing housing. Note: If the plastic spherical cap continues to turn, but does not come off, check that you locked the screw driver into the shaft. If the plastic spherical cap will not turn by hand a 9/16” Socket can be used on the belt (inside the bottom of the plastic spherical cap) to loosen it. You may need to clean grass or debris out of the recess first.” • When doing the above putting a socket on the belt pully and plastic spherical cap bolt, the hex bolt M8x25 broke. (no information provided as what the thread pitch is. M8 bolts can either be M8-1x25 or M8-1.25). • Under section for Maintenance Position, it say to Remove the bolt and wing nut that is holding the trimmer in the trimming operating positions. There is no wing nut! Poor customer service, had problems with shipping and had to file a warranty claim because of the broken hex bolt that broke off in the shaft (part # TS600-00011). I am still waiting to here back from customer service. Filed on line about 2 weeks ago. Also there does not seem to be any way to order parts, on there web site. This 3pt trimmer has less than 5 hours on it as it is sitting broken.