While my first impression of the tree shear was that it was well made after the first ten minutes of use the pin that controls the shear rotation pulled through its holder. The pin had no shoulder to prevent it from being pulled through. The pin had only a spot weld holding the handle on which easily broke off. The bracket that holds the pin bent in also I have straightened the bracket and reinforced it with a square of 3/8” steel. Made a large pile of brush in three hours two days ago. I would like to know if a hydraulic rotation is an option for this shear and what it looks like. I would also like to know if there could be a clamp to hold small trees while more are being cut so as to reduce trips back and forth to the pile. I hope my observations and questions are distributed within your company. Steve