The outside extension forks are about 2" out of alignment with the center two hollow channel fork sheaths. Center two sheaths angle upward instead of being level with two outside extended fork, so it will not go under the bundles of sheetrock without damaging the materials. Also, the sheath tapers to quickly instead of allowing our "measured fork width, height and depth" prior to ordering. Our smallest lift forks will only go 3/4 the way into the sheath and therefore we can not pin the attachment correctly behind our forks and the attachments slides off our forks when trying to back out from under the bundles. It isnt operating as it should and right now is a $2000 paperweight. How can we fix this? I've taken photos of whats explained, if you have a way to allow me to sent them to someone, I need too. -Mike Bailey