Contemporary Square Twist Spindle 41mm Reviews

5 Rating 1 Reviews
Read Go Banana Reviews

Contemporary Square Twist Spindle  Spindles are supplied in either Pine or White Oak timber and in the following measurements: 900mm x 41mm x 41mm 1100mm x 41mm x 41mm. You can download the Cheshire Mouldings Benchmark Fitting Instructions manual from hereContemporary Square Twist Spindle  USE THE SPINDLE CALCULATOR ABOVE TO ESTABLISH HOW MANY SPINDLES YOU NEED  New Contemporary Twisted Square Stair Spindles are available in Pine and Oak. Can be used with any 41mm grooved handrails and base rails on the staircase or landing area. Select any of newel posts or leave existing newel in place and just re-new the spindles and rails using the contemporary Square Twisted Spindles and Rails  Spindles are supplied in the following measurements: 900mm x 41mm x 41mm 1100mm x 41mm x 41mm. Fitting Square Twist Stair Spindles  Newel Posts are fitted first followed by base rails and handrails. When fitting spindles to your stair case you must first find the angle of the stairs, this can be achieved using a sliding bevel or angle finder. Cut your spindles top and bottom to the right angle and length. Try each spindle between the hand and base rail sliding it from the bottom of the staircase to the top. This will ensure any rail run-out will be allowed for. Once all of your spindles are cut you will need to cut your spindle spacers from the fillet strip provided in our rails. This is cut at the same angle as the stairs making sure that the spindles are spaced no more 99mm apart. Start at the bottom of the staircase and insert the first spacer followed by a spindle. We suggest dry fitting all of your spindles and spacers before fixing into place then bed all spindles and spindle spacers on PVA wood adhesive. We recommend pinning the spindles in place, panel pins should be inserted below the level of the spindle spacer so the spacer will hide the head of the panel pin.  Counter sink any panel pin heads showing on the spindle spacer into the timber and fill with a matching wood filler. Follow the same procedure for the landing spindles.  Staircase Building Regulations  Handrail heights on the staircase are measured from the front bullnose of a step to the top of the handrail. Spindles must not allow a sphere 100mm in diameter to pass between two spindles.  If you are unsure, please contact us or your building inspector for new builds.  You can download the Cheshire Mouldings Benchmark Fitting Instructions manual from here

About Go Banana:

The UK's first marketplace for building supplies.

Visit Product Page
Author didn't leave any comments.
Helpful Report
Posted 2 years ago