How would you rate the overall quality of the product?
Very Low
Okay
Very Good
How would you rate the value of the product for the money?
Very Low
Okay
Very Good
How difficult or easy is the product to assemble, use, or operate?
Very Difficult
Average
Very Easy
How well does the product perform / function?
Very Weak
Okay
Very Good
“I really really disapprove this front retract housing Mount . It is very very fragile and weak to it's material for such a large EDF jet . Even in the designers of this jet knowing that this mount is going to be a very bad idea to produce this jet with for the price being asked for is ridiculously sick . Not even talking about to complete trouble of replacing the Mount . The retract mounting holes could have at least been solid . Although the design of such weak material is just as worse .”
How would you rate the overall quality of the product?
Very Low
Okay
Very Good
How would you rate the value of the product for the money?
Very Low
Okay
Very Good
How difficult or easy is the product to assemble, use, or operate?
Very Difficult
Average
Very Easy
How well does the product perform / function?
Very Weak
Okay
Very Good
“The plastic pieces itself are 100% fine. The issue is removing the old nose plastic tray that holds the nose gear. I did not cut any foam away like some reviewers described. I cut the fuselage in half along the line where it was glued, and tried to spread it out, but that was impossible, since the two half's of the fuselage were held together by the old very well glued tray. I cut the tray in half which allowed me to spread the two half's of fuselage. Then it was close to impossible to remove the plastic tray (each half) from each half of fuselage (very well glued in) and I am a very handy person. So I am giving it 1 star because it is close to impossible to replace it. Yet, I am very happy that Freewing sells the replacement part. One of the reasons I always shop on Motion RC website is because they always have in stock replacement parts.”
“everything I needed. all pieces worked fine but extracting the old (broken) tray that holds the nose gear was more than I had expected. I had to cut half of the fuselage off to get the old piece out. Not a user friendly design.”
How would you rate the overall quality of the product?
Very Low
Okay
Very Good
How would you rate the value of the product for the money?
Very Low
Okay
Very Good
How difficult or easy is the product to assemble, use, or operate?
Very Difficult
Average
Very Easy
How well does the product perform / function?
Very Weak
Okay
Very Good
“First, I was under the impression that this would be easy however I basically had to cut it out and re-glue it back together. I understand that this has to be done at an inexpensive cost however a little reinforcement would have been nice. Also, the retracts should be offered in aluminum,”
