How would you rate the overall quality of the product?
Very Low
Okay
Very Good
How would you rate the value of the product for the money?
Very Low
Okay
Very Good
How difficult or easy is the product to assemble, use, or operate?
Very Difficult
Average
Very Easy
How well does the product perform / function?
Very Weak
Okay
Very Good
“I had a dilemma it took a little creativity. Nevertheless the service department Martin included as well as his team made a resolution and I couldn’t be happier with how they accommodated me...”
How would you rate the overall quality of the product?
Very Low
Okay
Very Good
How would you rate the value of the product for the money?
Very Low
Okay
Very Good
How difficult or easy is the product to assemble, use, or operate?
Very Difficult
Average
Very Easy
How well does the product perform / function?
Very Weak
Okay
Very Good
“I bought these parts to do a complete re-build of a crashed OV-10. The parts arrived bagged and undamaged. The plastic fittings to mount the outer wings to the center wing and the plastic fittings to mount the center wing to the main fuselage were all factory installed. The ailerons and flaps all come factory hinged in addition to the control horns and ball link fittings installed. The four flap servo and two aileron servo bays and covers are also factory installed. NOTE: The outer wing panel flap / aileron servo wire ribbon cable fitting is NOT included. You will need to salvage those parts or purchase them separately.The entire wing parts fit together exactly as the original kit. getting the mass of wiring through is time consuming but not a real problem. I used the original go get-em wire or if you have something similar to help pull the servo leads through. There are quite a few wire leads, but if you mark them all before you start installing the wires through, it makes identification of which wire goes where a whole lot easier. Trying to identify which wire does what is a pretty daunting task, if you do not first mark each wire first.Also, I would pull the motor power wire leads through first, as these are the heaviest and thickest wires followed by the ribbon cable wires. The individual servo leads for the aileron, flaps, throttle, elevator and LED lights can be pulled through individually with the go get-em wire.If you are going to do a complete re-build after a major crash, I would also recommend ordering a replacement screw hardware set, unless you are able to salvage all the mounting screws from the original fittings. I am happy to report everything fit perfectly as in the original kit.”
