How would you rate the overall quality of the product?
Very Low
Okay
Very Good
How would you rate the value of the product for the money?
Very Low
Okay
Very Good
How difficult or easy is the product to assemble, use, or operate?
Very Difficult
Average
Very Easy
How well does the product perform / function?
Very Weak
Okay
Very Good
“This build was pretty much straight forward, the landing gear was a bit of a pain to install, the overall quality of the model is good for the money, the tail blades supplied were garbage , I fashioned my own set out of rotor tech 92 mm carbon fiber tail blades and painted them to scale ( all and any tail vibration went away with the slightly smaller and better tail blades I installed) the main rotor blades also not the best and NOT actually carbon fiber by the way , as advertised , main and tail blades supplied are glass fiber build ups ( not that it’s the end of the world but Motion / Roban should stop pitching the kits as having carbon fiber blades none of them actually do I have built and own several , and after a lot of sanding and refinishing I have the main blades balanced out and true . all other vibrations went away and the machine runs smoothly, for the build I used Mks MKS HV777A servos on the cyclic and tail as well , these servos produce 506 ounce inches of torque @ 7.2 volts I have found these servos more than adequate on all my large scale builds even those with Fenstron tails . Flight control is Vbar Neo ... power delivery is scorpion 130 HV esc running 12 s 5000mah , the drive motor is XNOVA 4035 470 KV , pulling and average of 44 amps @ about 1320 rotor rpm , with 7 minute flights landing with about 30% battery left , the helicopter is about 80% finished, I will be adding more my own scale details , as well as graphics , the machine flies very well and I have 14 flights on it so far , in conclusion, the Roban large scale kits while not perfect they are a good buy and a quick build and a lot easier on making mechanics work as with a scratch build scale projects I have built in the past , other than a few quirks, I have been happy with all my Roban builds”
How would you rate the overall quality of the product?
Very Low
Okay
Very Good
How would you rate the value of the product for the money?
Very Low
Okay
Very Good
How difficult or easy is the product to assemble, use, or operate?
Very Difficult
Average
Very Easy
How well does the product perform / function?
Very Weak
Okay
Very Good
“Nice looking heli, very tough to work if you need to repair especially the landing skids if you bend them. I need access & repair the wood that supports the aluminum skids, looking at cutting and installing access panels underneath the fuselage for future access. The rear tail shakes around during flight which takes away from the realism.”
