The Little Giant MPN 506065 represents a fully-integrated water removal solution engineered specifically for above-floor drainage applications where conventional gravity-fed plumbing proves impractical. This WRSC-6 model Drainosaur system delivers a complete package combining a one-third horsepower shaded pole motor, diaphragm-activated automatic operation, epoxy-protected cast iron pump housing, and a factory-assembled 3.5-gallon polypropylene basin measuring exactly 10.5 inches in height—all connected through an 8-foot power cord terminated with a standard 115-volt plug ready for immediate residential or light commercial basement installation. Manufacturing precision defines this MPN 506065 utility pump through its pressure-sensitive diaphragm switch mechanism that activates between 4 and 7 inches of water accumulation and deactivates between 1 and 3 inches, eliminating the tangle-prone float assemblies found in competing sump pump designs. The carbon ceramic shaft seal works in conjunction with dual bearing assemblies supporting the nylon impeller housed within the polypropylene volute, while the transparent polycarbonate cover allows visual monitoring of water levels and sediment accumulation without system disassembly. This specific 506065 configuration achieves 46 gallons per minute flow capacity at 5-foot discharge head, reaching maximum vertical lift capabilities of 18 feet through its 1.5-inch female national pipe thread discharge connection, making it uniquely suited for laundry tray evacuation, wet bar sink drainage, dehumidifier condensate removal, air conditioner water disposal, water softener backwash handling, and utility sink applications where effluent must travel upward against gravity before entering municipal sewage lines or septic systems. WRSC-6 Series Engineered Cast Iron Housing & Protective Epoxy Coating System For Extended Corrosion Resistance The Little Giant 506065 employs precision-cast iron construction for its submersible pump housing, selected specifically for this WRSC-6 model due to cast iron's superior heat dissipation properties, mechanical strength characteristics, and dimensional stability under continuous water immersion conditions. Cast iron's approximately 4 percent carbon content enables the material to develop a natural graphite surface layer when exposed to aqueous environments with pH values between 6 and 10, providing inherent corrosion resistance that self-regenerates during normal operation. The factory-applied epoxy coating on this 506065 unit creates a chemical barrier against aggressive water chemistries, protecting the cast iron substrate from electrochemical attack, flow-accelerated corrosion, and premature degradation caused by varying mineral content in municipal water supplies or private well systems. This dual-layer protection system—combining cast iron's metallurgical properties with polymeric surface treatment—extends operational lifespan significantly compared to aluminum or thermoplastic pump housings that lack similar thermal management capabilities. The epoxy formulation bonds at the molecular level to the prepared cast iron surface, creating a continuous barrier resistant to chlorine exposure, sulfate contamination, and pH fluctuations common in basement plumbing applications. The 506065's cast iron construction maintains structural integrity when handling intermittent liquid temperatures up to 125 degrees Fahrenheit, accommodating hot water discharge from washing machines, dishwashers, or water heater drainage without thermal shock damage that could crack inferior materials. This specific housing design distributes motor-generated heat evenly throughout the submerged assembly, preventing localized hot spots that accelerate bearing wear and seal degradation in continuous-duty basement installations. Mid-Level Diaphragm Switch Activation Technology Eliminating Float Mechanism Complications & Basement Space
Visit Product Page
