This is the 3rd bed from Get Laid and if it had been the 1st, there wouldn't have been two more. I had to complete the manufacturing process for them with ill-fitting headboard pieces where I had to re-drill what were slightly mis-aligned screw holes. A rubber mallet was bought to help and finally I had to buy a special drill bit to complete the rebates for two raised washers, photos of the "before" and "after" are attached that shows the impression that Get Laid left without actually cutting into the leg. What had taken a maximum of 3 hours for each of the earlier beds took instead the best part of two days including B&Q visits. On the positive side I now own a rubber mallet.