Good but... Gate safety pins should be PTO shaft locking pins commonly used on trailer hitches to keep them closed. The pins provided are short and thin and can pop out over big bumps. Also the manufacturing of the gate latches could be better. The latch springs should be tighter and the gap between the latch bottom and catch top should be smaller, perhaps 1/8 inch max not 1/4. The latch itself is not that long so any movement of the latch upward will allow it to open with the gap as big as it is and the springs as soft as they are. I know because somehow when I arrived on one trip only one safety pin was holding the gate up. Small improvements would go a long way in this area. I replaced the safety pins with locking pins. $9.99 on amazon - PTO Shaft Locking Pin 3/8" x 2-1/4" ( PACK of 3)