Part came In early and on top of that it came with everything you need, I personally did it in two parts I just jacked the front of the car up didn’t need to take anything off apart from the under cover which for some reason had 28 screws lol, there was no need to take the inter cooler out I attached the rubber part to the bottom half of the charge pipe and attached that to the Inter cooler then I went from top and literally just slided down top half got it aligned with the silicon tube and pushed it in, then I checked the connection to make sure there was no gaps and the it was tightened properly, then comes the part which I struggled a bit, the part that goes in your engine the c-clamp has to click so you have to make sure you leave the clips inside it and just push it onto it and it’ll click, then just make sure it’s fitted correctly, run your finger on the side of it and the back to see there no gaps and viola Ps if you still have a drive train error just turn the car off for 30 seconds to a minute after installation and turn it back on 👌🏽