I was sceptical of buying a non-approved seat but honestly, these things are awesome. I swapped out a set of Cobra Suzuka’s which probably sounds mad but these fit in my NA much, much better. Pair them with the Tuckin99 side slider rails and you can get the drivers seat to the point where you can’t fit your hand between it and the floor of the car while still being able to move the seat. If you do go that route, you’ll need 4x10 mm standoff spacers to fit those rails with this seat and some 30-35 mm length M8 bolts. You also can’t fit the screw on handle for the rail slider if you put the seats as low as possible but that’s really no big deal, replace the handle with whatever you like, I used an all thread cap end. Also, if you dig around a bit, you’ll find that the Car Make Corn’s seats look suspiciously identical to these seats right down to the rubber gaskets for the belt holes. Make of that what you will but these things get delivered quickly and cost half as much…