This mount does not work on any optics ready Sigs. This red dot rear sight dovetail mount is easy to install and allows you to mount a red dot on your pistol without having to permanently modify the slide.
This mount fits (including but not limited to):Sig Sauer P210A StandardSig Sauer P220Sig Sauer P224Sig Sauer P225Sig Sauer P225-A1Sig Sauer P226Sig Sauer P227Sig Sauer P228Sig Sauer P229Sig Sauer P238Sig Sauer P239Sig Sauer P245Sig Sauer P320Sig Sauer P938Sig Sauer SP2022Sig Sauer M11-A1Sig Sauer MK25Bersa Thunder UC Series (9/40/45)Bersa Thunder HC Series (9/40/45)FN 509Sig Sauer #8 Sight CutsThis mount does not fit:Sig Sauer 1911sSig Sauer P220 10mm HunterAny Optics Ready Sig Sauer i.e. P226 Legion RX, P229 RX, P320 X-Carry etc.Sig Sauer P210 TargetSig Sauer P365 (The dovetail cut is too deep to work with our mount)FN 509 Tactical
EGW sight base is compatible with Sig #8 rear sight cuts.
Material: 7075 AluminumCoating: Matte Black HardcoatOverall Length: 1.604"Overall Width: .99"Mounting Hardware: (2) 6-32 Button Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment:
Vortex Defender Series
OSight SE
Bushnell RXS-100
Crimson Trace CTS-1500
Holosun 407K*
Holosun 407k-GR
Holosun 507K*
Holosun 507k-GR
Holosun EPS-GR*
Holosun EPS-RD*
Holosun EPS-Carry-GR*
Holosun EPS-Carry-RD*
Jpoint
Leupold Delta Point Pro
Optima
Redfield Accelerator
Shield RMS
Shield RMSc
Shield SMS
Sig Romeo Zero
Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.Simply remove the rear sight on your gun and replace it with our mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.Installation Instructions- Remove the rear sight*- Install the EGW Sight Mount in the dovetail- Tighten set screw (if applicable)- Place the red dot sight on the EGW Sight Mount(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)- Apply blue Loctite to the provided mounting screws- Torque mounting screws to 15in/lbs
WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.
Modification of your firearm may nullify the manufacturer's warranty.This product should be installed and checked by a qualified gunsmith.No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.
Warning: This product may be alloyed with trace amounts of lead and other elements which are known to the State of California to cause reproductive harm and cancer. To prevent exposure, do not alter the product by welding, grinding, etc. For more information, go to www.P65Warnings.ca.gov.
Location:
52 BELMONT AVE,
QUAKERTOWN
Pennsylvania
18951
