Mounting Hardware is Included
This mount fits:
All XD Models that are NOT the Optics Ready ModelThis includes, but is not limited to:
Springfield XD® MOD.2® – 3" SUB-COMPACT MODEL
Springfield XD® MOD.2® – 3.3" SUB-COMPACT MODEL
Springfield XD® MOD.2® – 4" SERVICE MODEL
Springfield XD® MOD.2® – 4" SERVICE MODEL THREADED BARREL
Springfield XD® MOD.2® – 5" TACTICAL MODEL
Springfield XD® 3" SUB-COMPACT MODEL
Springfield XD® 4" SERVICE MODEL
Springfield XD(M)® 3.8" COMPACT MODEL
Springfield XD(M)® 3.8" MODEL
Springfield XD(M)® 4.5" MODEL
Springfield XD(M)® 4.5" THREADED BARREL MODEL
Springfield XD-S® 3.3" MODEL
Springfield XD-E™ 3.3" SINGLE STACK
Springfield XD-E™ 3.8" SINGLE STACK
Springfield XD-E™ 3.8" SINGLE STACK
Springfield Hellcat (NON OSP - NOT OPTIC READY)
Does not fit:
Springfield XD(M)® 5.25" COMPETITION SERIES MODEL
Any Optics Ready Springfield XD
Material: 7075 AluminumCoating: Matte Black HardcoatOverall Length: 1.604"Overall Width: .99"Mounting Hardware: (2) 6-32 Button Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment:
Vortex Defender Series
OSight SE
Bushnell RXS-100
Crimson Trace CTS-1500
Holosun 407K*
Holosun 407k-GR
Holosun 507K*
Holosun 507k-GR
Holosun EPS-GR*
Holosun EPS-RD*
Holosun EPS-Carry-GR*
Holosun EPS-Carry-RD*
Jpoint
Leupold Delta Point Pro
Optima
Redfield Accelerator
Shield RMS
Shield RMSc
Shield SMS
Sig Romeo Zero
Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.Simply remove the rear sight on your gun and replace it with our mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.Installation Instructions- Remove the rear sight*- Install the EGW Sight Mount in the dovetail- Tighten set screw (if applicable)- Place the red dot sight on the EGW Sight Mount(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)- Apply blue Loctite to the provided mounting screws- Torque mounting screws to 15in/lbs
WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.
Modification of your firearm may nullify the manufacturer's warranty.This product should be installed and checked by a qualified gunsmith.No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.
Warning: This product may be alloyed with trace amounts of lead and other elements which are known to the State of California to cause reproductive harm and cancer. To prevent exposure, do not alter the product by welding, grinding, etc. For more information, go to www.P65Warnings.ca.gov.
Location:
52 BELMONT AVE,
QUAKERTOWN
Pennsylvania
18951
