“My saw performs well. There are few minor things, but, nothing major. It needs a handle in the middle of the carriage, Not just on the side to push on when starting a cut.”
“Assembly instructions are sub par- have had the mill set up for months and the cable system that holds the head up is a poor design. It sags and cuts tapers- would have probably bought a green mill had I known this. Was missing a bunch of hardware when I got it- customer service was great- going to work with them again on head sag”
“Starts on first or second pull most times. Has good power for a 144" x 1 1/4" blade. Gets pretty good fuel economy also. My only real gripe is the idle. Not having an Idle stop is a terrible design flaw. You have to use the throttle cable to adjust the idle. I was dumbfounded when I discovered this. I've been around all sorts of engines for the last 50 years and I have never seen anything like this.
Other than that, it does a pretty good job.”
“Check all bolts on cutting head after a few hours of use, as well keep checking saw blade alignment. Had a roller bearing fall out of a guide.
Saw has run flawlessly other than this.
Make sure to drop log rests as you go.”