Cetus Extruder Heater Kit-V2 (1 Brass Nozzle and 2 Steel Nozzles) Reviews

4.40 Rating 10 Reviews
Read Tiertime Reviews

About Tiertime:

Developer and manufacturer of 3d printers

Visit Product Page

Phone:

+86 13810480728

M Ciepiela
I both this one to upgrade my old extruder v1 and in my opinion latest version heat's up at least 3 times quicker than my old one. Quick and easy installation just plug out the old one and plug in the new one.
Helpful Report
Posted 1 month ago
A
VERY GOOD. USED AS SPARE. GREAT PRODUCT. BACK AGAIN
Helpful Report
Posted 4 months ago
K Van Haarlem
Very nice steel nozzles that will reduce nozzle wear when printing abrasive materials. Installation is easy and straight-forward.
Helpful Report
Posted 10 months ago
M Kiss
Nozzle sizes can be changed much quicker on the reworked V2 extruder nozzle. It seems to make a bit flatter layers, because of the wider flat part at it's end. The original had some sticking problems if melted plastic got under the silicone insulating cup, and the brass tips were more pointier. Also the steel nozzles can be used longer with more abressive filaments.
Helpful Report
Posted 1 year ago
J TREGASKIS
I love my Cetus and the steel nozzle is so much better... a must-have buy! Thank you Cetus
Helpful Report
Posted 1 year ago
F FB3 FH Dortmund
Author didn't leave any comments.
Helpful Report
Posted 1 year ago
R Reali
Author didn't leave any comments.
Helpful Report
Posted 1 year ago
A
bad to say the least! The nozzle prints badly. always in extrusion and the jam filament with every print! high printing temperatures (240 ° for the pla) and considering that the Studio UP software does not work (always carries the machine in over temperature) I am forced to use the old Cetus 3d which does not allow the creation of dedicated profiles (without considering that with OSX is still impossible to do)
Helpful Report
Posted 1 year ago