VW T6.1 Gloss Black Front Splitter For Under Genuine Bumper Reviews

4.8 Rating 8 Reviews

About Vee Dub Transporters:

Our company is a small family business which is growing at an unbelievable pace, and we believe that our customers’ needs are of the utmost importance. We are committed to meeting all your needs. As a result, a high percentage of our business is from repeat customers and referrals. We would welcome the opportunity to earn your trust and deliver you the best service in the industry.

Visit Product Page

Phone:

08002922005

Email:

help@veedubtransporters.co.uk

Location:

Unit 1 Manor Drive,
Sileby
Leicestershire
LE12 7RZ

Visit Product Page

“Sadly couldn't fit it as need to raise van off ground to remove protective plates on underside.Self tap screws supplied not going to hold it so need access to fit decent nut/bolts. Shoved it in the shed.”

Helpful Report

Posted 2 months ago

“Fitted very easily .I've worked on vehicles for years but even someone with hardly any knowledge will be able to fit this part just finishes the front of the vehicle off very nicely”

Helpful Report

Posted 1 year ago

Author didn't leave any comments.

Helpful Report

Posted 1 year ago

Author didn't leave any comments.

Helpful Report

Posted 2 years ago

“Great fitment finishes off the front of my van nicely ..”

1 Helpful Report

Posted 3 years ago

Thank you for your five-star review Stephen, your new Splitter looks great! We hope to see you back at Vee Dub again soon!

Posted 3 years ago

“A great addition to my t6.1”

3 Helpful Report

Posted 3 years ago

Thank you for your five-star review on our T6.1 Front Splitter Phil, we hope to see you back at Vee Dub again soon!

Posted 3 years ago

“Fitted great Buy again”

1 Helpful Report

Posted 3 years ago

Thank you for your five star review about our T6.1 Splitter!

Posted 3 years ago

“Fitted this to my T6.1 today. Top top when fitting without removing any of the bumper - find the centre point of the van and splitter and clamp the spitter in place from the rear at the centre points (it’s easier with 2 people), don’t drill/bolt the 4 centre holes just yet. Then use the screws to screw in place both outside edges so they fit snuggly and match perfectly - I had to pull/hold them in place while I screwed in the 4 screws at each side so they matched the skirt perfectly. Then for the 4 centre holes work from the outside in and find a drill bit that just goes through the pre-drilled holes of the splitter and drill a hole through the splitter hole into the skirt behind it. Then use the nuts and bolts to tighten, do the same for all 4 front mounting holes. A little patience and it will fit perfectly …. and it looks pretty neat too!”

2 Helpful Report

Posted 4 years ago

Thank you for your in-depth five-star review James!

Posted 4 years ago