Please note if purchasing 1 x 3 metre trim, the trim will arrive as 2 x 1.5 metre sections. This is to prevent damage in transit. The A type trim is a drip trim, fitted to the lowest edge of the roof usually where the rainwater flows into the gutter. The A200 is compatible with the B260 upstand trim. Dimensions Girth: 200mm; Depth: 90mm; Length: 3metres Fitting Instructions Two support battens should be fixed to the perimeter of the roof to provide space for the gutter to fit behind the trim, with the outer batten attached 10mm lower than the inner batten to allow the trim to sit flush with the roof. Apply trim adhesive to the batten in 30mm beads at 300mm centres, rub the trim into place and nail to the decking. Do not nail through the front of the trim. If the pitch of the roof is only minimal, rainwater is likely to hold behind the trim. A planning machine can be used to take 2mm off the deck to allow the trim to lay flush with the board. A. Whilst we would recommend GRP Trims with a fibreglass roof (the fibreglass will bond better). If you decide to use lead or metal trims, ensure the lead or metal is clean and free from contaminates. Use G4 sealer when overlapping with the fibreglass.
About FibreGlassDirect:
FibreGlassDirect is an online shop which supplies quality, fibreglass raw materials to the UK and Ireland. We are based in Leeds, West Yorkshire and our Head Office is in Newry, Northern Ireland.
We have been online since 2009 but have over 60 years of experience as part of the Tricel Group.
We offer an extensive range of resins, topcoats, gelcoats and ancillaries for a wide range of industries. Some of our key supplies are used for Fibreglass Flat Roofing, Fibreglass Ponds, Boat Repairs and Castings for Decorative Items.
Phone:
+44 (0) 28 4175 3738
Email:
sales@fibreglassdirect.co.uk
Location:
Milltown Industrial Estate, Unit 4, Greenan Road
Warrenpoint
BT34 3FN
