Magnetic Quick-Release for Helmet Air Pumper - CLEARANCE with 1.75" Bar Mount Reviews

4 Rating 9 Reviews

Visit Product Page

Phone:

8885417223

Email:

media@ruggedradios.com

Location:

509 traffic way,
arroyo grande
California
93420

Visit Product Page

“They sent me a mount with a defective, stripped out screw head. When trying to fit the mount the screw stuck inside. Couldn't tighten or loosen it. I had to cut the bracket to remove it. I asked for a replacement and they laughed in my face. Said they never had that issue. Never again will I buy anything from them. Oh, and the first bracket they sent was the wrong size. When trying to get the right size, they tried blaming me for their mistake. Be aware!”

1 Helpful Report

Posted 4 months ago

Rob, We do not do business like that. If your experience had you feeling this way, I would love to discuss a resolution with you. I left you a voicemail and look forward to your return call. Joe Zeidler Sales Manager 805-541-1696

Posted 4 months ago

“Excellent for pumper helmets. No need to mess around on where your hose is at. Great product”

Helpful Report

Posted 1 year ago

“After fighting my hose on the side of my helmet I decided to purchase one of these. It makes getting in and out of the car so much easier.”

Helpful Report

Posted 2 years ago

“Works well to hook up and unhook air pumper while getting in and getting out.”

Helpful Report

Posted 2 years ago

“The magnets are constantly coming out of the release and need to be re-glues. I have since switch to the Maglock Magnetic Forced Air Helmet Connector”

Helpful Report

Posted 2 years ago

“I have two of these air pumper helmet quick disconnects in my Rzr. They work excellent and make getting into and out of the car very easy.”

Helpful Report

Posted 2 years ago

“I ended up not using the high quality Scoche clamp/bracket as my 73 year old shoulder wouldn't allow the motion shown in the video. Instead I cut a short piece of reinforced hose to attach it directly to the pump outlet to push the mag clamp forward enough that I can reach it. I wish there was an accessory mount like the one offered (and I used) to mount the blower housing…then I could hang the mag connector from the center roll bar without removing the roof skin.”