How would you rate the overall quality of the product?
Very Low
Okay
Very Good
How would you rate the value of the product for the money?
Very Low
Okay
Very Good
How difficult or easy is the product to assemble, use, or operate?
Very Difficult
Average
Very Easy
How well does the product perform / function?
Very Weak
Okay
Very Good
“I ran them on #5 for 2 hours from a 2s4200mAh Li-Ion pack and used 2502mAh.... So, 1250mA an hour and constant 1.1-1.5A drai. All LEDs flash rapidly when 2s voltage hits 6.8v... very cool! Let's me know when to land lol.After 120min the hottest LEDs were obviously the full-on bulbs and they were at 42-45C. The controller chip was 52C... no airflow on the bench. Good length on leads but will need to splice in some additional lengths... no biggie.I will make sure there is a small entry/2× exit hole for the heatsinks to breathe.Also, 100g meh..... the plane weights @13500g and I'd really like to see it and these are the ticket! Will buy again for all my future 120/130mm EDFs.”
How would you rate the overall quality of the product?
Very Low
Okay
Very Good
How would you rate the value of the product for the money?
Very Low
Okay
Very Good
How difficult or easy is the product to assemble, use, or operate?
Very Difficult
Average
Very Easy
How well does the product perform / function?
Very Weak
Okay
Very Good
“Best light ever owned works great you can use three switches to activate different functions and they are very bright during daylight easy to see and coordinate your landing i have about four of my turbine jets and scale airplane highly recommended enjoy;-)”
How would you rate the overall quality of the product?
Very Low
Okay
Very Good
How would you rate the value of the product for the money?
Very Low
Okay
Very Good
How difficult or easy is the product to assemble, use, or operate?
Very Difficult
Average
Very Easy
How well does the product perform / function?
Very Weak
Okay
Very Good
“All lights work but cannot change modes all lights flash in a sequence but cannot change to a more realistic mode which it is supposed to have. The instructions are very sparse and do not go into detail on how to change modes if using a receiver channel or separate switch does not change modes. No help using motionrc as they say read the instructions. Appears to be a good product but be prepared to use a strange sequenceJohn labelle”
How would you rate the overall quality of the product?
Very Low
Okay
Very Good
How would you rate the value of the product for the money?
Very Low
Okay
Very Good
How difficult or easy is the product to assemble, use, or operate?
Very Difficult
Average
Very Easy
How well does the product perform / function?
Very Weak
Okay
Very Good
“The kit is nice, complete and functions as expected. Very bright! Heat sinks on back of leds are about 1/2”x1/2” square and 1/4” deep. That said the led board is bigger at 3/4” and 6 sided. Have to account for that during install. Unsure how much heat these will generate when mounted into foam planes yet (my case 2.1m carbon cub ss). Wires are too short for intended scale planes, expect to extend the leads. Lights are not labeled but wires are color matched ie: has red it’s red led, green is green and black/white is white and power module is labeled. Overall decent but could be improved but limited choices for this level of brightness.”
How would you rate the overall quality of the product?
Very Low
Okay
Very Good
How would you rate the value of the product for the money?
Very Low
Okay
Very Good
How difficult or easy is the product to assemble, use, or operate?
Very Difficult
Average
Very Easy
How well does the product perform / function?
Very Weak
Okay
Very Good
“These are really bright lights and look great on my Carbon Z Cub. My only complaint is that a light or two cuts off when I reach into the fuselage to install or remove the flight battery and then I have to wiggle the plugs to get them back on. Too weak of a plug connection.”
