“The Lo-Pro jack arrived today and I tested on my car. I drive a Prius. I am replacing a hydraulic bottle jack. The Lo-Pro jack barely lifted the car off the ground, so I added a couple of 2x4 studs to give it more lift, and it works great. I got a new socket wrench and 7/16 socket to go with, put them in the bag with the jack, and everything fits easily below the deck in the trunk of my car. Craftsmanship is beautiful, and the lift was easy, smooth, both on the way up and coming back down. A good socket wrench, socket extension and 7/16 socket is a must-have, be sure to keep it close at hand with the jack.”
“Bought this jack to use in a Hellcat Challenger that does not have a factory jack but comes with a compressor/tire slime repair kit only. So I carry a tire repair kit and this jack. In a roadside emergency, I use this jack to pick up the car by the lower control arm, so its 6" lift height works just right in this case. I made an additional hard urethane pad to put between the jack lift saddle and the car's lower control arm, as well as a short riser, only about 3/4" in height, that the jack fits into and has a rubber mat on the bottom so that jack will not easily slip or slide on the pavement. I also keep a Capri Tools 7/16 Six Point ratcheting wrench in the jack case as well as a long handle 3/8 drive ratchet, 6" extension and 7/16 Six point deep socket. Perfect emergency roadside setup. Fits nicely in the storage area in the trunk and does not take up too much room. Thank you Ca Car Covers for this amazing setup!”
“Awesome little jack for lowered vehicles, would be nice if it raised higher, however I understand due to the lower profile that would take a lot more engineering! After you raise it there is easy access for your large floor jack to get the vehicle as high as you need it! Works great on lowered Vw ghia , gets the wheels off the ground all by itself !”
“Easy to order, prompt delivery! Gotta admit that I am not using this item to lift a car, but a heavy piece of equipment in my studio, it's genius! I'd been looking for a solution to lift a 300lb piece and move it, and this is it. My only wish would be that the fitment onto which you put your drive socket be a larger size (10mm? lol)”
“I purchased this jack in order to be able to jack up my lowered Harley Davidson when it is on the lift table. Most lift table scissor jacks are 3.5 to 4 inches which will not fit under my bike. At @ one inch this jack is great. Well made and even looks good. It should be represented better on the biker forums. I had never seen it before until I ran across a video of it being used to lift a street rod. In addition to lift table work; I can see a big market for riders of lowered bikes who are tired of rolling them up on a board to get a regular lift jack under the bike.”
“The low profile jack is extremely well built, as Corvette owners know, not much is available in jacks that will slide under the Vette. The storage bag is also very nice, I attached a Grandsport embroidered patch to the Bag for a custom look.I also purchased a 7/16 ratcheting box wrench to put in bag so I am ready to go, if and when I need to lift car.While the price is not low, I think given its quality it is fairly priced.”
