Tiertime Reviews

"I received a new mainboard to fix my Cetus 2 and it is much appreciated. "

"Cetus2 w\/Klipper fully operational. Thanks for great service."

"Cetus2 w\/Klipper fully operational. Thanks for great service."

"New Main Board solved the problem (sudden death)."

"Hello Tiertime Team,\r\n\r\nTiertime's service and support is very good.\r\n\r\ntop work\r\n\r\nKudos to Eric who does an excellent job and always helps me.\r\n\r\nVery good.\r\n\r\nI am very happy and satisfied with Tiertime.\r\n\r\nI myself am the proud owner of two UP mini 2 printers.\r\n\r\nWhen the new UP mini 3 is available on the market at Christmas, I will order and buy the 3D printer right away.\r\n\r\nMany Thanks.\r\n\r\nGreeting Chrisitan from Germany near Regensburg."

"Tiertime has always gone out of its way to make sure a brotha is happy. Seriously without them, I wouldn't have given up. Thanks, much appreciated.\r\n-Dez"

"I was able to figure it out on alot of things I ruled out. I ruled out hot end by replacing it I ruled out cable by also replacing that. Turned out to be a solder joint that was not solder on the logic board on top of the extruder. That connects to the hot end. The bottom of the pin on the board was soldered. But not on the top of the pin on the top side of the board. It's a double layered board where there are traces that are on top of the extruder board and on the bottom. The top part of that pin had zero solder on the contact making it defective from factory. Being out of warranty I had to solder that pin properly that goes to the hot end. That solved the nozzle too hot completely and nozzle too cold error completely. "