“Re: Elevator pushrod to short [#T411527]
Inbox
Motion RC Support
Fri, Jul 14, 9:35 AM
Hi Martin, Please check under the wing. The adjustments for the elevator and rudder are there. I've circled them on the picture. Regards, Ozzy www.motionrc.com
Martin DuLude
AttachmentsFri, Jul 14, 6:04 PM
Yeah that's what it was. It was a little involved removing the wing because I glued the long air scoop to both sections of the fuselage...not fun at all. Sure e
Motion RC Support
Mon, Jul 17, 7:25 AM (11 days ago)
Hi Martin, Setting up the pushrods is one of the most basic setup elements. If this was an issue for you then this hobby just may not be for you. Regards, Ozzy
Martin DuLude
Mon, Jul 17, 9:55 AM (11 days ago)
to Motion
Pal, I've been in this hobby probably longer than you've been alive. So don't patronize me with your unprofessional attitude...”
“I recommended MotionRC to a club mate recently. He bought a Gripen. Vectored thrust servo not working so you replaced it. Then ESC blew after just four flights: you refused to replace as he had soldered on a different connector.
Can’t recommend you again after such poor service.”
“I would not likely recommend as you are selling your Nexa re branded line from VQ Models that I know from personal experience the ARF’s are absolute junk. If you want to be the best you should emulate the best in the rc world such as Extreme Flight or AJ Aircraft.”
